CL-P10 Uninterruptable Power Supply/Battery Pack

The CL-P10 power pack was engineered to provide constant power protection for most FREEZE CONTROL biofreezers manufactured since May 1992. It provides 100% power failure protection for over three hours on a single charge. The CL-P10 operates from its internal battery, from mains, or from an external 12-volt source.

The size of the CL-P10 is 121 x 184 x 241mm. It weighs 5.7 kg with the battery installed and has a conveniently placed carrying handle. Custom travel cases are available in a variety of configurations to accommodate the CL-P10 with any model freezer.
PRODUCT CODE: P10

Travel Case

Custom form-fitted, ATA-approved transport case for biofreezer systems is built to withstand the rigors of road and air travel. The case incorporates heavy duty hardware, internal bracing, and ABS exterior over plywood laminate. Compartments to house accessories are included. Travel case available for all models of biofreezers.
PRODUCT CODE: CLZ

Thermometers

TEGAM™ 871A External Output Digital Thermometer and K-Type Probe
TEGAM 871A interfaces with a chart recorder for independent temperature monitoring. External output is scaled to 1mV per °C. Comes complete with cable.
PRODUCT CODE: 871A

L1040™ Dual K-Type Digital Thermometer

The L1040 is an accurate, economical and reliable way to double-check temperatures in any freezer, thaw bath, warm stage or other laboratory device, and it provides the practitioner with precise verification of actual thermal or cryogenic conditions. The extremely small K-type probe (0.060") allows its integration inside a standard specimen carrier, such as a straw or cryovial. It provides the system with a temperature range of -250°C to 1372°C with an accuracy of ±0.1% of reading ±1°C across its range.
PRODUCT CODE: L1040

TL13 Datalogger Module for CL3300, CL3000, CL863

Allows recording of specimen temperatures by interfacing the advanced features in CryoGenesis V4 Software with FREEZE CONTROL temperature controllers CL3300, CL3000 and CL863.
PRODUCT CODE: TL13

XTL™ Extended Cryochamber Lids

Extended lid for FREEZE CONTROL cryochambers accommodates straws with plug-ends or double-length straws.
PRODUCT CODE: XTLT

     To accommodate double-length ½ml or ¼ml straws (120mm in length).

PRODUCT CODE: XTLM

     To accommodate Identification Plugs (ID Rods) wiith ½ml or ¼ml straws (60mm in length).

PRODUCT CODE: XTLS

     Standard cryochamber lid (20mm in length)

XTLS         XTLM         XTLT

Cryobath Lids

BLS
LNS standard replacement lid.
PRODUCT CODE: BLS

BLH
LNS cryobath lid with center hole and offset handle to accommodate chambers equipped with extended lids.
PRODUCT CODE: BLH

BLC
PETG clear cryobath lid with integral handle for DX2 bath.
PRODUCT CODE: BLC